How To Clean The Printer (Cleaning Sheet) - SATO GZ4e Series Operator's Manual

4.2 HOW TO CLEAN THE PRINTER (CLEANING KIT) (Cont'd)
5. Lightly pull out the media sensor guide, remove it and
clean its bottom area with a cotton cloth moisten with
cleaning liquid. Fix back the media sensor guide after
cleaning.

4.3 HOW TO CLEAN THE PRINTER (CLEANING SHEET)

If certain stains on the print head cannot be removed easily with cotton swabs dabbed in cleaning solution, the
cleaning sheet is used for clearing such stubborn debris on the print head.
1. Make sure the printer is powered off and remove the
power cord.
2. Lift up the main cover.
3. Release the green print head lock lever by turning
counterclockwise.
The print head is now accessible.
4. Remove the media and the ribbon.
5. Put the head cleaning sheet between the print head
and the platen roller. The coarse side of the cleaning
sheet should face the surface of the print head
elements.
6. Now remount the print head by turning the head lock
lever clockwise until it latch on. The print head should
lock into place firmly.
7. Using both hands, pull the cleaning sheet outwards,
toward your body. This will remove any dirt stuck to the
print head.
8. When the cleaning sheet has been removed, perform
steps 5 to 7 to repeat the cleaning procedure one or two
more times.
9. When no more additional dirt appears on the cleaning
sheet after it has been pulled out, you can stop cleaning
with the sheet.
10.Unlatch the print head and use the cleaning pen from
the cleaning kit to gently remove any remaining dirt from
the print head.
GZ4e Series Operator Manual
Section 4: Cleaning and Maintenance
Media sensor guide
Cleaning sheet
Page 4-3