SATO GZ4e Series Operator's Manual page 50

Section 3: Configuration and Operation
3.9 EMULATION MODE (Cont'd)
MENU
EMULATION MODE
EMULATION SELECT
AUTO MANUAL
EMULATION SELECT
SZPL SATO
SIZE MODE
CMD AUTO
TEAR OFFSET
V : +000
SENSOR TYPE
N B G
LABEL TYPE
D T
LABEL SIZE
WIDTH 0832
LABEL SIZE
HEIGHT 1424
Page 3-26
EMULATION MODE (TABLE 3-5)
Is the first menu screen of the Emulation Mode. The emulation mode was to create
similar LCD menu options of the emulated printer, providing similar functionality for
the end users.
Allows the selection of the Emulation mode, Auto or Manual. Default setting is
Manual.
Allows the selection between SZPL emulation and SATO. Default setting is SATO.
Note: When changing SZPL emulation mode to SATO mode, execute DEFAULT
SETTING before starting the operation, and vice versa.
Allows the selection of size mode for SATO, CMD (command) or AUTO.
If AUTO is selected, the EMULATION SELECT mode will automatically change from
MANUAL to AUTO.
Default setting is CMD.
Allows the Tear Offset Position to be set. The range of setting is -999 to +999.
Allows the selection of the Media Sensor type.
N: No sensor
B: I-mark
G: Gap sensor
The default setting follows DSW 2-2 setting.
Allows the selection of the Label type.
D: Direct Thermal
T: Thermal Transfer
The default setting follows DSW 2-1 setting.
Allows to set the label width. The default value is set as 832 dots. (GZ412e:1248
dots)
The range of label width setting is 0000 to 0896 dots and changes with increments
of 8 dots. (GZ412e: 12 dots)
Allows to set the label height. The default value is set as 1424 dots. (GZ412e:2136
dots)
The range of label height setting is 0000 to 9992 dots and changes with increments
of 8 dots. (GZ412e: 12 dots)
DESCRIPTION
GZ4e Series Operator Manual