Dsw 3 Setting Command (Szpl Command) - SATO GZ4e Series Operator's Manual

Section 3: Configuration and Operation
3.3 SOFTWARE DIP SWITCH COMMAND (Cont'd)

3.3.4 DSW 3 Setting Command (SZPL command)

Hex code ~
<7E>
Default Value ,0,0,0,0,0,0,0,0
FUNCTION
FORMAT
PARAMETER
EXAMPLE
SPECIAL NOTES
Page 3-10
DSW 3 SETTING
ESC
<1B>
16 16
To set the DSW-3 settings by software command
~ + <ESC> + DS3,a,b,c,d,e,f,g,h
a [DSW 3-1]
b [DSW 3-2]
c [DSW 3-3]
d [DSW 3-4]
e [DSW 3-5]
f [DSW 3-6]
g [DSW 3-7]
h [DSW 3-8]
^XA
~ <ESC>DS3,0,0,0,0,1,0,0,0
^XZ
Above code snippets will set the DSW 3-5 to ON and so, the print start signal (external trig-
ger) is Enabled when the printer restarts.
1 This command is valid only when DSW 2-8 is ON.
2 The parameters of this command cannot be omissible. The command will be ignored if
the parameters are missing or incorrect.
3 The LCD menu and DSW settings will become effective after the printer restarts.
4 Users can send this command to printer in Normal mode and Flash Download mode.
5 Selection from PRINTER TYPE LCD under Advanced Mode will change software DSW
3-1 and 3-2 accordingly.
6 The DSW settings will be fixed and maintained until the next ~<ESC>DS3 command is
sent.
7 DSW-3 software command settings will be maintained when printer factory clear and
default settings are performed.
8 When hardware DSW 2-8 is switch to OFF, software DSW-3 command settings will be
automatically set to default values (software DSW3 default setting: DSW all OFF).
DS3
<44> <53> <33>
16 16 16
= 0 : OFF / 1 : ON
= 0 : OFF / 1 : ON
= 0 : OFF / 1 : ON
= 0 : OFF / 1 : ON
= 0 : OFF / 1 : ON
= 0 : OFF / 1 : ON
= 0 : OFF / 1 : ON
= 0 : OFF / 1 : ON
~ESC + DS3
Parameter
,a,b,c,d,e,f,g,h
[Operation Mode]
[Pitch Sensor Used / Not Used]
[Backfeed Enabled / Disabled]
[Print Signal Disabled / Enabled]
[External Signal Type]
[Repeat Print Signal Disabled / Enabled]
GZ4e Series Operator Manual