Local Area Network (Lan) Ethernet; Basic Specifications; Dip Switch Settings - SATO GZ4e Series Operator's Manual

7.5 LOCAL AREA NETWORK (LAN) ETHERNET

Local Area Network (LAN) interface is an optional Plug-In Interface Module that can be installed by replacing
the 3-in-1 Combination Interface Module. The driver that must be loaded onto the host computer and
configured to support the TCP/IP network protocol using a 10/100BaseT LAN connection. Details for loading
the LAN driver are contained on the CD-ROM that is shipped with each optional LAN interface module.

7.5.1 Basic Specifications

Connector
Cable
Cable Length
Power Supply
Protocol
IP Address
Subnet Mask
Gateway Address

7.5.2 DIP Switch Settings

SWITCH
1
2
3
4
GZ4e Series Operator Manual
SPECIFICATIONS
RJ-45 Receptacle
10/100BaseT Category 5
100 m or less
Powered from printer
Protocol for Driver (cyclic response mode)
Protocol for Driver (ENQ response mode)
0.0.0.0 to 255.255.255.255
0.0.0.0 to 255.255.255.255
0.0.0.0 to 255.255.255.255
DIP SWITCH SETTINGS
Reserved (setup prohibited).
LAN board EEPROM initialization (configuration).
Print configuration details on a label.
Print a self-diagnosis of the board onto a label.
Section 7: Interface Specifications
Status3
Status5
SETTING
Page 7-9