2.3 HOW TO LOAD THE MEDIA (cont'd)
8.
Remount the print head by turning the green print head lock lever clockwise until it latch on. The print
head should lock into place firmly.
9.
After loading the media and the carbon ribbon, close the main cover and do a test print to check that the
media roll has been loaded properly. See Section 3.10 Test Print Mode for instructions on how to run test
print.
Notes:
•
Be careful not to get your fingers pinched while closing the main cover.
•
To load the media in the dispenser, please refer to Section 2.3.3 To Route the Label when Using
the Optional Dispenser, for further instructions.
Caution
•
When replacing media, bear in mind that the print head and its surrounding area remain hot. Keep
your fingers away from these areas to prevent injury.
•
Avoid touching even the edge of the print head with your bare hands.
2.3.2 How to Load Fan-fold Media
If using fan-fold media, set them on a flat surface behind the printer and remove the cover from the external
media slot on the rear panel. Pass the labels (printing side up) through the slot and over the media roll
holder. Refer to Figure 2-5.
Route the label following the steps explained for the media roll above.
GZ4e Series Operator Manual
Figure 2-5, Fan-fold Media Loading
Section 2: Installation
External
media slot
Media holder guide
Page 2-5