Loading Media With The Optional Cutter; Loading Media With An Optional Dispenser And Liner Discharge Outlet - SATO CL4NX Operator's Manual

3 Loading the Ribbon and Media
3.5.3

Loading Media with the Optional Cutter

Refer to the procedure in
load the media.
For models with a cutter installed, pull the tab
the cutter unit in the direction shown, then open up
the cutter-open lever before passing the media
through it.
After loading media, close the cutter-open lever and
then push the tab
CAUTION
Be careful not to touch the cutter blade.
3.5.4 Loading Media with an Optional Dispenser and Liner Discharge
Outlet
This section describes the procedure to dispense the
label and eject the liner out of the printer.
1
Refer to steps 1 through 6 of
3.5.1 Loading Media Roll
media.
2
Press the tab q at the front of the printer to
open the dispenser unit w.
44
CL4NX/CL6NX Operator Manual
Section 3.5.1 Loading Media Roll
in the reverse direction to lock it.
q
Section
to load the
or
Section 3.5.2 Loading Fan-fold Media
of
q
2
2
1
1
to
1