Operation And Configuration - SATO GZ4e Series Operator's Manual

Section 3: Configuration and Operation

OPERATION AND CONFIGURATION

Before using the printer, it is best to read this manual thoroughly first. Otherwise, you may disturb default
settings around which the instructional procedures in this manual are based upon.
The printer may be manually configured via the LINE and FEED buttons with the LCD display or the
potentiometers on the operator panel of the printer. All the printer's buttons are used either singularly, or in
conjunction, to perform configuration activities.
Many of these settings can also be controlled via software commands and, as well as with our SATO All-In-
One Tool software application.
In case of conflict between software and control panel settings, the printer will always use the last valid
setting. If you load a label job that includes software settings and then enter a new setting via the LCD panel,
the manually set values will be used by the printer. If you set the values manually and then download a job
with software settings, the software settings will be used.
GZ4e Series Operator Manual Page 3-1