Sonicwall Management - SonicWALL TELE3 SP Administrator's Manual

RADIUS Client Test
You can test your RADIUS Client user name and password by typing in a valid User name in
the User field, and the Password in the Password field. If the validation is successful, the
Status messages changes to Success. If the validation fails, the Status message changes to
Failure. Once the SonicWALL has been configured, a VPN Security Association requiring
RADIUS authentication prompts incoming VPN clients to enter a User Name and Password into
a dialogue box.

SonicWALL Management

SonicWALL SNMP Support
SNMP (Simple Network Management Protocol) is a network protocol used over User
Datagram Protocol (UDP) that allows network administrators to monitor the status of the
SonicWALL Internet Security appliances and receive notification of any critical events as they
occur on the network. SonicWALL Internet security appliances support SNMP v1/v2c and all
relevant Management Information Base II (MIBII) groups except egp and at. The SonicWALL
replies to SNMP Get commands for MIBII via any interface and supports a custom SonicWALL
MIB for generating trap messages. The custom SonicWALL MIB is available for download from
the SonicWALL Website and can be loaded into third-party SNMP management software such
as HP Openview, Tivoli, or SNMPC.
To configure SNMP in the SonicWALL Internet Security appliance, log into the SonicWALL
Management interface. Click Access, then Management. The SNMP configuration panel is
displayed.
Page 84 SonicWALL TELE3 SP Administrator's Guide