Example Of Manual Key Configuration For Two Sonicwalls - SonicWALL TELE3 SP Administrator's Manual

14. Click Update to add the remote network and close the VPN Destination Network
window. Once the SonicWALL has been updated, a message confirming the update is
displayed at the bottom of the browser window.
15. Click Advanced Settings and check the boxes that apply to your SA:
• Enable Windows Networking (NetBIOS) broadcast - if the remote clients use
Windows Network Neighborhood to browse remote networks.
• Apply NAT and firewall rules - to apply NAT and firewall rules to the SA or just firewall
rules if in Standard mode.
• Route all internet traffic through this SA - if forcing internet traffic from the WAN to
use this SA to access a remote site.
• Default LAN Gateway if specifying the IP address of the default LAN route for incoming
IPSec packets for this SA. This is used in conjunction with the Route all internet traffic
through this SA check box.
• VPN Terminated at LAN - select one of the three terminating points for the VPN tunnel.
16. Click OK to close the Advanced Settings window. Then click Update to update the
SonicWALL.
Configuring the Second SonicWALL Appliance
To configure the second SonicWALL appliance, follow the same configuration steps as the first
SonicWALL. You must enter the same SPIs and Encryption keys as the first SonicWALL
appliance into the settings of the second SonicWALL appliance.

Example of Manual Key Configuration for Two SonicWALLs

Widgit, Inc. wants to connect their main office with a branch office on the East Coast. Using a
SonicWALL PRO 300 and a TELE3 SP, they can configure a secure VPN tunnel between the two
sites. The main office has the following network settings:
• SonicWALL LAN IP address - 192.168.11.1
• LAN subnet mask - 255.255.255.0
• WAN router address - 209.33.22.1
• SonicWALL WAN IP address - 209.33.22.2
• WAN subnet mask - 255.255.255.224
The remote office has the following network settings:
• SonicWALL LAN IP address - 192.168.22.222
• LAN subnet mask - 255.255.255.0
• WAN router address - 207.66.55.129
• SonicWALL WAN IP address - 207.66.55.130
Page 136 SonicWALL TELE3 SP Administrator's Guide