Gtmf Remote Installation - Regency Horizon HZ42STEPV Owners & Installation Manual

DFBC = digital fi replace burner control
1) Remove the faceplate and glass door to access to DFBC &
battery pack tray.
2) Lift DFBC and battery pack up and out.
3) Remove the hi/lo knob from the valve head, if installed, by removing
2 screws as shown below.
4) Install the stepper motor in the same location the hi/lo knob was
removed from - with 2 screws as shown below.
5) Install 4 - AA batteries into the receiver, ensure correct polarity.
Regency Horizon™ HZ42STEPV Gas Fireplace

GTMF REMOTE INSTALLATION

6) Remove the module tray on the right side of the unit to access the DFBC
7) Plug receiver wires into the back of the receiver and bundle wires
with the wire clip as shown below.
8) Connect GTM motor wire from the stepper motor to the wire connector
from the receiver wire harness.
9) Program Receiver and transmitter (refer to manual)
Note:
DO NOT USE 4 AA batteries on the control module; the DFBC is
now powered by the receiver batteries in the wall.
INSTALLATION
Wire Clip
35