Punch Unit - Sharp MX-M283N Installation Manual

6) Open the front door of punch unit.
7) Engage the pawls of the rear side of front cover (Package part
No. 5), attach the front cover with the fixing screw (Package
part No. 1).
B. Connection of connector of the finisher and

punch unit

1) Remove the fixing screws, and remove the rear cover.
2) Connect two connectors of the finisher to the PWB of punch
unit, and fix the harness to the clamp.
C. Install of the Connection fixture F/R
1) Install the Connection fixture F (Package part No. 7) to the
main unit with the fixing screws (Package part No. 4).
2) Install the Connection fixture R (Package part No. 8) to the
main unit with the fixing screws (Package part No. 4).
D. Check of the connected position of main unit
and finisher
1) Engage the finisher that has installed punch unit to the main
unit, and temporarily fix.
* Insert the rail of the finisher unit into the rail reception fixture
of main unit, fix temporarily.
MX-M503N MX-PNX6A/B/C/D 10 – 3