Sharp MX-M283N Installation Manual page 92

C. Mount the data security kit ROMs to the
control PWB unit.
Remove the ROMs (PROG1 and PROG2) from the control PWB
and replace them with the data security kit ROMs (MFP_PRG1 and
MFP_PRG2).
When mounting the data security kit ROMs, insert them to the
same positions in the same orientations as those before replace-
ment until they click and ensure that the inserted ROMs are locked
with the sockets.
PROG1
PROG2
FAX IMG EXT
PCL/BARCODE
PS KANJI
D. Reattach the control PWB and the right cabinet
rear.
• If the fax box unit is installed, carry out steps 1), 2), and 3)
additionally.
1) Connect the interface cable to the control PWB unit.
2) Push the interface cable into the recessed portion of the sheet
metal on the control PWB unit.
3) Attach the snap band to the sheet metal of the control PWB
unit.
1
2
4) Push the control PWB unit into the main unit.
5) Secure the unit with the two screws.
• If the fax box unit is installed, carry out step 6) addition-
ally.
3
MX-FR14U/FR14/FR15U/FR15/FR24U 22 – 2
6) Fit the interface cable into the right cabinet rear cover.
7) Attach the right cabinet rear cover to the main unit.
At this time, check that the four hooks are properly fitted to the
main unit.
8) Secure the right cabinet rear with the screw.
Hook 1 Hook 2
7
8
9) Attach the ozone filter cover to the main unit.
• Reconnect the cables that have been removed in step B to
the original positions of the control PWB unit.
E. Turn on the main power switch of the main
unit.
1) Insert the power plug of the main unit to the outlet.
2) Turn on the main power switch.
3) Turn on the power switch located on the operation panel.
4) Enter the product key of the DSK.
Serial Number
PS3 Expansion Kit: [Enable]
Internet Fax Expansion Kit: [Enable]
E-mail Alert and Status: [Enable]
Data Security Kit: [Enable]
Hook 3
Hook 4
6
ON
xxxxxxxxxx
Register
Register
Register
Register