Sharp MX-M283N Installation Manual page 54

F. Attaching the cushion
1) Attach the cushion (S) (package part No.14), the cushion (M)
(package part No.15) and the cushion (L) (package part No.16)
to the position indicated in the figure.
Cushion (M)
Reference
Refer-
ence
Cushion (L)
Cushion (S)
G. Check of the connected position of main unit
and finisher
1) Insert the rail of the finisher into the slit on the rail reception
sheet metal of the main unit, install the finisher.
2) Remove the screw, and remove the connector cover on rear
side of the finisher.
3)
Reference
Refer-
ence
Reference
Refer-
ence
H. Adjustment
1)
MX-M503N MX-FN11 9 – 5
Check that the center of the screw hole of the finisher is in the
range of specification of an oval hole of the connection fixture
that exist on main body rear side.
* When not the range of specification, progress to the proce-
dure of "H. Adjustment".
If the adjustment is not required, remove the screws from
the screw hole directly and push the caster into it until the
installation fixing.
Remove the finisher from the main unit.