Sharp MX-M283N Installation Manual page 86

[20] MX-SMX3
MX-M503N
1. Unpacking
A. Parts included
No. Packed part name
1 Expansion memory board
2. Installation
A. Turn off the power switches of the main unit.
1) Turn the power switch located on the operation panel to the
"OFF" position.
2) After checking that the operation panel has gone out, open the
front cabinet and turn the main power switch to the "OFF" posi-
tion.
3) Remove the power plug of the main unit from the outlet.
B. Pull out the control PWB.
• If cables are connected to the control PWB unit, remove all
cables.
1) Push the location indicated in the illustration to unlock, and
remove the ozone filter cover from the right cabinet rear.
2) Remove the screw from the right cabinet rear.
3) Remove the right cabinet rear.
1
Quantity
1
OFF
MX-M503N MX-SMX3 20 – 1
Service Manual 4) Remove the two screws from the control PWB unit.
• If the fax box unit is installed, carry out steps 5), 6), and
7) additionally.
5) Pull out the control PWB unit and remove the snap band.
6) Remove the interface cable from the frame.
7) Remove the connector.
8) Pull out and remove the control PWB unit.
4
3
8
4
2
C. Installation of the expansion memory
1) Install an expansion memory board to the DIMM1 slot of the
MFPC PWB.
DIMM1
* Note for installation
a) Insert the expansion memory board into the slot diago-
nally from above.
NOTE: When handling an expansion memory board, be
careful not to touch the terminals.
7
6
5
5