Sharp MX-M283N Installation Manual page 111

: '10/Jun/18
1
1
Check section B.
Is
No
there a re-
sistance?
Yes
Check section C.
Is there
No
a separating
section.
Yes
End of the
adjustment
Adjust hinge
E until the
separation in
section C is
deleted.
(Counter-
clockwise)
* The bosses in section A
and B are excessively
pressed. (The right
side is separating.)
MX-M503N MX-RP11 28 – 5
d) Check section B.
Place the RSPF height adjustment sheet between section B
and the RSPF glass height adjustment resin surface (a), and
close the RSPF unit.
Slowly pull out the RSPF height adjustment sheet.
Check to insure that a slight resistance is felt when pulling out
the RSPF height adjustment sheet. (If the boss in section B is
in contact, it is O.K.)
Be careful not to put the book sensor (b) on the height
*
adjustment sheet.
e) If it can be pulled out without resistance, turn the hinge in
section E clockwise to adjust.
f ) Check section C.
Check to confirm that the projection in section C in the right
front side of then RSPF bottom is in contact with the glass
surface (b).
B
b
a
E
b
C
C
b