Important Troubleshooting Information; Troubleshooting Reference Diagram; Figure 26: Troubleshooting Reference Diagram - Hughes HN9400 User Manual

Satellite router

Hide thumbs Also See for HN9400:

Table of Contents

Chapter 4

Important troubleshooting information

HN9400 Satellite Router User Guide

1038555-0001 Revision B

unless you are a qualified technician. Pressing this switch could cause the router to become

inoperable.

the router using the Restart function in the System Control Center. When so instructed, do not

power cycle the router. Doing so will destroy data that may be useful for troubleshooting.

router, you should remove and then re-apply power. If the satellite router uses an AC/DC power

supply, disconnect the AC power cord from the power source (power strip, wall outlet, or surge

protector). If the satellite router uses a DC/DC power supply, disconnect the DC input cable

connector from the router's power supply. In either case (AC/DC or DC/DC), do not unplug the

power cord from the satellite router's rear panel. Doing so could result in static electricity

discharge that could shock you and/or damage the router.

If you need to use any of the troubleshooting procedures provided in this chapter, you may find

it useful to refer to

shows all power and cable connections for a properly installed HN9400 satellite router.

Do not use the recessed rescue switch on the router's rear panel

This user guide contains some procedures that instruct you to restart

When this user guide instructs you to power cycle the

Troubleshooting

on page 33. This diagram

Table of Contents