Confirming That Web Acceleration Is Operational - Hughes HN9400 User Manual

Chapter 4

Confirming that Web Acceleration is operational

HN9400 Satellite Router User Guide
38
1038555-0001 Revision B
a) Unplug the power cord from the power source.
b) If the router is connected to a DC power source, unplug the DC input cable from the
satellite router's power supply.
c) Wait 10 sec.
d) Plug the power cord back into the power source.
e) If the power source is DC, plug the input cable back into the power supply.
the power cord from the router's rear panel. Doing so could result in static electricity discharge
that could shock you and/or damage the router.
5. If TCP Acceleration is still disabled, power cycle the Ethernet device according to the device
documentation.
6. If TCP Acceleration is still disabled, restart the computer.
7. Check the TCP Acceleration Status field again.
If TCP Acceleration is enabled but you still cannot access the Internet, go to
that Web Acceleration is operational
If TCP Acceleration is still disabled, contact your service provider for assistance.
Note: TCP Acceleration Status may also be Not Operational (problem with the receive
or transmit link) or Impaired. Impaired status may result from a number of factors; in
many cases it clears within a minute or two.
Note: This section applies only if the NOC operator has enabled Web Acceleration on the
satellite router.
Web Acceleration is a Hughes feature that enhances browsing performance on non-secure web
sites. Follow these steps to confirm that Web Acceleration is operating properly:
1. From any System Control Center page, observe the System Status button indicator.
• If the indicator button is green, Web Acceleration is functioning normally.
• If the indicator button is yellow, Web Acceleration may not be operational. Continue to
the next step.
2. Click the System Status link to access the System Status page.
3. Observe the message in the Web Acceleration Status field.
If the Web Acceleration Status is Operational, Web Acceleration is enabled. Proceed to
Confirming NOC connectivity
Note: Web Acceleration Status may be Operational or Inactive during normal
operation. Connecting does not indicate a problem unless it persists for more than a
few seconds.
4. If the Web Acceleration Status is Not operational, Web Acceleration Status is disabled.
Follow these steps:
a) Make sure the router is transmitting and receiving. See
page 36 and Confirming the transmit signal
stated in these sections.
Do not power cycle the satellite router by unplugging
on page 38.
on page 39.
on page 36. If necessary, troubleshoot as
Troubleshooting
Confirming
Confirming the receive signal on