Port Forwarding Configuration Page; Figure 20: Port Forwarding Configuration Page - Hughes HN9400 User Manual

System Control Center
Parameter
LAN1 IP Address
LAN1 Subnet Mask
LAN1 MAC Address
LAN2 IP Address
LAN2 Subnet Mask
LAN2 MAC Address
NAT IP Address
NAT Subnet mask

Port Forwarding Configuration page

of Gateway software to the router, the newer version number is
displayed.
The satellite router address. The default router address is
192.168.0.1. A different router address can be configured.
Range of addresses available to the satellite router.
MAC address for the satellite router.
Address available for a second LAN connection.
Subnet mask (range of available addresses) available for a second
LAN connection.
MAC address a second LAN connection.
The Internet routable public IP address assigned to the router. NAT
translates this address to local private addresses in the range
192.168.0.x that can be used by the devices on your local network
(where x = 0–9).
The NAT subnet mask (range of available addresses) assigned to
the router is always 255.255.255.255.
Note: The Port Forwarding Configuration page and link are present on your HN9400
only if they have been enabled by the NOC.
The Port Forwarding Configuration page and the link to it are present only if port forwarding
has been enabled and made visible on the router by the NOC.
On this page you can define rules for allowing TCP and UDP traffic on the Internet to access
servers on your network.

Figure 20: Port Forwarding Configuration page

Explanation
HN9400 Satellite Router User Guide
1038555-0001 Revision B
Chapter 2
23