Confirming That The Satellite Router Is Commissioned; Figure 28: System Info Page - Hughes HN9400 User Manual

Troubleshooting

Confirming that the satellite router is commissioned

If you have tried all of these procedures and cannot access the Internet, try them all again. If you
still cannot access the Internet, contact your service provider.
For most of these troubleshooting procedures you use the router's System Control Center. To
access the System Control Center on a computer connected to the router:
1. Open a web browser such as Internet Explorer.
2. In the browser's address bar, type www.systemcontrolcenter.com or 192.168.0.1.
3. Press Enter.
The System Control Center home page opens.
To confirm that the router is commissioned:
1. At the System Control Center, click the System Info link.
The System Information page appears.

Figure 28: System Info page

Note: The System Info page for your installation may show different fields and values.
2. In the HN9400 section, check the Site ID line.
If the numeric site ID appears, the satellite router is commissioned. Proceed to
the receive signal on page 36.
HN9400 Satellite Router User Guide
1038555-0001 Revision B
Chapter 4
Confirming
35