Long-Term Storage - Shindaiwa DG37MK-P Owner's And Operator's Manual

(11) Oil Separator Filter Replacement
Replace
Remove the cover, and
1
remove the O-ring and oil
separator filter.
Assemble a new O-ring to
2
the cover and spread a
thin layer of oil on the
O-ring.
Assemble a new oil
3
separator filter and tighten
the cover by hand.
< NOTE >
 Replace with a new O-ring each time the oil separator filter
is replaced.
 Oil separator filter part no. (with O-ring):1J419-05811 (Kubota part no.)

11. Long-Term Storage

WARNING : INJURY
 Before performing any equipment check or maintenance, stop the engine,
and remove the engine key. A person performing the maintenance should
always keep the key.
CAUTION : FIRE
 Always be sure to wipe up any spilled fuel or oil.
 Allow the generator to cool before covering with the protective cover.
CAUTION : BURNS
 Do not touch the engine and surrounding components immediately after
stopping the equipment, while temperature can reach extremely high.
(1) Storage Procedures
Perform the following maintenance procedures before storing this generator if it is not
going to be used for two months or more.
Remove the battery.
1
(Refer to section "8-7. Checking the Battery Replacing the Battery".)
Replace the engine oil.
2
(Refer to section "10. Inspection/Maintenance (1) Engine Oil Replacement".)
Drain the fuel from the fuel tank and filter.
3
(Refer to section "10. Inspection/Maintenance (5) Cleaning / Changing Fuel Filter".)
(Refer to section "10. Inspection/Maintenance (6) Draining Water from the Fuel Tank".)
Remove the starter key and store in a secure location.
4
(Refer to section "10. Inspection/Maintenance (9) Spill Containment
Cleaning/Inspection".)
Every 1000 hours
Oil Separator
36
Loosen Tighten
Cover
O-ring
Oil Separator
Filter
Oil Separator