Draytek Vigor2130 Series User Manual page 196
High speed gigabit router
Hide thumbs
Also See for Vigor2130 Series:
- User manual (296 pages) ,
- Quick start manual (41 pages) ,
- User manual (39 pages)
Table of Contents
Advertisement
Destination Subnet
Source Start Port
Source End Port (optional)
Destination Start Port
Destination End Port (optional) Type a value as the destination end port. Such value will be
Action
E
x
a
m
p
l
e
:
E
x
a
m
p
l
e
:
Refer to the following example.
1.
Use TSPC mode to connect to IPv6 network.
PC get ipv6 IP: 2001:5c0:1503:7400:30e4:139d:53c8:3a1e
2.
Connect PC to http://www.ipv6.org/ with IPv6 IP address.
A message will appear from the web page:
You are using IPv6 from 2001:5c0:1503:7400:30e4:139d:53c8:3a1e
3.
Set firewall rule to block all TCP traffic from this IP address.
4.
Open IPv6 >> IPv6 Firewall Setup and press Add New Rule.
In the following dialog, please configure the page with the following values.
Type the subnet mask here if you choose Subnet as
Destination IP Type.
Type a value as the source start port. Such value will be
available only TCP/UDP is selected as the protocol.
Type a value as the source end port. Such value will be
available only TCP/UDP is selected as the protocol.
Type a value as the destination start port. Such value will
be available only TCP/UDP is selected as the protocol.
available only TCP/UDP is selected as the protocol.
Set the action that the router will perform for the packets
through the protocol of IPv6.
Accept – If the IPv6 packets fit the condition listed in this
page, the router will let it pass through.
Drop - If the IPv6 packets fit the condition listed in this
page, the router will block it.
Welcome to the IPv6 Information Page!
188
Vigor2130 Series User's Guide
Advertisement
Table of Contents
