Ports - Draytek Vigor2130 Series User Manual

IP Address
Subnet Mask
Enable DHCP
Start IP Address
IP Pool Counts
Lease Time
After finishing all the settings here, please click OK to activate them.
4 . 2 . 2 P o r t s
4 . 2 . 2 P o r t s
Ports page is used to change the setting for LAN ports. You can set or reset the following
items. All of them are described in detail below.
Port
Link
Current
Speed Configured
Type in private IP address for connecting to a local private
network (Default: 192.168.1.1).
Type in an address code that determines the size of the network.
(Default: 255.255.255.0/ 24)
DHCP stands for Dynamic Host Configuration Protocol. The
router by factory default acts a DHCP server for your network
so it automatically dispatch related IP settings to any local user
configured as a DHCP client. It is highly recommended that you
leave the router enabled as a DHCP server if you do not have a
DHCP server for your network.
You can configure the router to serve as a DHCP server for the
2nd subnet. Check the box to enable DHCP server setting.
Enter a value of the IP address pool for the DHCP server to start
with when issuing IP addresses. If the 2nd IP address of your
router is 220.135.240.1, the starting IP address must be
220.135.240.2 or greater, but smaller than 220.135.240.254.
Enter the number of IP addresses in the pool. The maximum is
10. For example, if you type 3 and the 2nd IP address of your
router is 220.135.240.1, the range of IP address by the DHCP
server will be from 220.135.240.2 to 220.135.240.11.
It allows you to set the leased time for the specified PC.
It displays current network interface.
It displays current connection status. Green light means the
LAN connection is successful.
It displays current speed that the router uses.
It can set the speed and duplex of the port. You can use the drop
down list to choose the required speed for the router. If you
have no idea in configuring speed, simple use the default setting,
118
Vigor2130 Series User's Guide