Checking The Clutch Push Rods; Installing The Clutch - Orion AGB-21G Service Manual

CHECKING THE CLUTCH PUSH RODS

1. Check:
oil tube 1
oil thimble spring 2
oil thimble 3
Cracks/damage/wear
fective part(-s).
2. Measure:
oil thimble spring
Out of specification
ble spring.
Oil thimble spring free length
17.5 mm

INSTALLING THE CLUTCH

1. Install:
clutch assy 1
NOTE:
Make sure that the teeth on the lock washer are
correctly aligned with the grooves on the clutch
boss.
thrust washer ,make sure the "OUT SIDE"
mark on the washer is upturned.
2. Tighten:
clutch boss nut 5
NOTE:
While holding the clutch boss with the universal
clutch holder , tighten the clutch boss nut.
3. Bend the lock washer tab
of the nut.
4 - 38
CLUTCH
Replace the de-
free length
Replace the oil thim-
60 Nm (6.0 m kg)
along a flat side