Front Brake Master Cylinder; Rear Brake Master Cylinder - Orion AGB-21G Service Manual

FRONT WHEEL AND REAR WHEEL

Front brake master cylinder

1. Install:
Brake master cylinder
Brake master cylinder bracket
Bolt (brake master cylinder bracket)
NOTE:
Install the bracket so that the arrow mark
face upward.
First tighten the bolts on the upper side of the
brake master cylinder bracket, and then
tighten the bolts on the lower side.
2. Install:
Brake lever
Bolt (brake lever)
Front brake master cylinder
NOTE:
Apply the lithium soap base grease on the
brake lever sliding surface, bolt and contacting
surface of the brake master cylinder piston.

Rear brake master cylinder

1. Install:
Copper washer
Brake hose
Union bolt
WARNING
Always use new copper washers.
CAUTION:
ACHTUNG:
Install the brake hose so that its pipe por-
tion directs as shown and lightly
touches the projection
master cylinder.
5 - 18
9 Nm ( 0.9 m • kg )
6 Nm ( 0.6 m • kg )
25 Nm (2.5 m• kg)
on the brake