Brake Fluid Level Inspection - Orion AGB-21G Service Manual

REAR BRAKE PAD INSPECTION AND REPLACEMENT
A
B
CAUTION:
Do not reuse the drained brake fluid.
Tighten the bleed screw 1 and 2.
Bleed screw 1 and 2:
18 Nm (1.8m
Nut 3 (brake caliper):
20 Nm (2.0m
3. Inspect:
Brake fluid level
Refer
INSPECTION" section.
4. Check:
Brake pedal operation
A softy or spongy feeling
brake system.
Refer
BLEEDING" section.

BRAKE FLUID LEVEL INSPECTION

1. Place the brake master cylinder so that
its top is in a horizontal position.
2. Inspect:
Brake fluid level
Fluid at lower level
Lower level
A Front
B Rear
Recommended brake fluid:
DOT #3 or DOT #4
WARNING
Use only designated quality brake fluid to
avoid poor brake performance.
Refill with same type and brand of brake
fluid; mixing fluids could result in poor
brake performance.
Be sure that water or other contaminants
do not enter master cylinder when refill-
ing.
Clean up spilled fluid immediately to
avoid erosion of painted surfaces or plas-
tic parts.
3 - 15
kg)
kg)
to "BRAKE FLUID
to "BRAKE SYSTEM
Fill up.
LEVEL
Bleed
AIR