Removing The Rear Shock Absorber Assembly; Removing The Drive Chain; Rear Shock Absorber And Swingarm - Orion AGB-21G Service Manual

REAR SHOCK ABSORBER AND SWINGARM

REMOVING THE REAR SHOCK ABSORBER
ASSEMBLY
1. Stand the motorcycle on a level surface.
WARNING
Securely support the motorcycle so that
there is no danger of it falling over.
NOTE:
Place the motorcycle on a suitable stand so that
the rear wheel is elevated.
2. Remove:
rear shock absorber assembly lower bolt 1
NOTE:
While removing the rear shock absorber as-
sembly lower pin, hold the swingarm so that it
does not drop down.
3. Remove:
rear shock absorber assembly upper bolt 1
rear shock absorber assembly
NOTE:
Raise the swingarm and then remove the rear
shock absorber assembly from between the
swingarm and relay arm.

REMOVING THE DRIVE CHAIN

1. Stand the motorcycle on a level surface.
WARNING
Securely support the motorcycle so that
there is no danger of it falling over.
NOTE:
Place the motorcycle on a suitable stand so that
the rear wheel is elevated.
2. Remove:
chain cover
3. Remove:
master link clip
(with interlocking slip-joint pliers )
4. Remove:
master link plate 1
master link 2
5. Remove:
drive chain
5-36