Installing The Swingarm; Installing The Drive Chain - Orion AGB-21G Service Manual

REAR SHOCK ABSORBER AND SWINGARM

INSTALLING THE SWINGARM

1. Lubricate:
bearings
spacers
pivot shaft
2. Install:
Swingarm
3. Install
rear shock absorber assembly
rear wheel
Refer to "INSTALLING THE REAR SHOCK
ABSORBER
WHEEL".
4. Adjust:
drive chain slack
Refer to "ADJUSTING THE DRIVE CHAIN
SLACK" in chapter 3.

INSTALLING THE DRIVE CHAIN

1. Lubricate:
drive chain
master link (New)
2. Install:
master link 1
master link plate 2
3. Install:
master link clip 1
CAUTION:
The closed end of the master link clip must
face in the direction of drive chain rotation.
Never install a new drive chain onto worn
drive chain sprockets; this will dramatical-
ly shorten the drive chain's life.
4. Adjust:
drive chain slack
Refer to "ADJUSTING THE DRIVE CHAIN
SLACK" in chapter 3.
5--41
Recommended lubricant
Molybdenum disulfide grease
ASSEMBLY"
Drive chain slack
30 50 mm
Recommended lubricant
Engine oil or chain lubricant
suitable for non-O-ring chains
Drive chain slack
30 50 mm
50 Nm (5.0 m kg)
and "REAR