Front Brake Pad Inspection And Replacement - Orion AGB-21G Service Manual

FRONT BRAKE PAD INSPECTION AND REPLACEMENT

FRONT BRAKE PAD INSPECTION AND
REPLACEMENT
1. Inspect:
Brake pad thickness A
Out of specification
set.
Brake pad thickness:
4.0 mm
<Limit>: 1.0 mm
2. Replace:
Brake pad
Brake pad replacement steps:
Remove Bolt 1 and 2
Loosen the Caliper
Remove Bolt 3 and 4
Replace the Brake pad
CAUTION:
Do not reuse the drained brake fluid.
Tighten the bleed screw.
Bleed screw 3 and 4 :
18 Nm (1.8 m • kg)
Install the Caliper Bolt 1 and 2
Bolt (brake caliper):
25 Nm (2.5 m • kg)
3. Inspect:
Brake fluid level
Refer to
INSPECTION" section.
4. Check:
Brake lever operation
A softy or spongy feeling
brake system.
Refer to
BLEEDING" section.
3 - 13
Replace as a
"BRAKE FLUID
"BRAKE SYSTEM
LEVEL
Bleed
AIR