Using Your Scanner - Symbol LS 6000 Series Product Reference Manual

! LS 6005-I000 (IBM 468X/469X) - The LS 6005 is fully
compatible with the entire line of IBM 468X/469X
terminals. It also accommodates the full line of Synapse
Smart Cables.
!
LS 6005-I090 (IBM 468X/469X with EAS) - The LS
6005-I090 also provides additional signal lines for EAS
deactivation (Checkpoint modes V and VII).

Using Your Scanner

If the scanner is powered by the host, ensure the host is
connected to a power outlet. When power is applied to the host,
the scanner powers up.
If the scanner is powered by an external power supply, ensure
the power supply is connected to a power outlet. When the
power supply is connected to the scanner, the scanner powers
up.
The green LED on top of the scanner illuminates and 3 power-
up beeps sound, indicating the scanner is operational.
The LS 6000's LED and beeper indicate scanning activity. These
indications are described in
Indications on page
If the scanner is inactive for more than a pre-programmed
length of time, it enters a low power "rest" mode to conserve
energy. When you need to scan again, just bring a bar code to
the scanner window to "wake up" the scanner.
1-2
LS 6000 Series Product Reference Guide
LED Indications
3-5.
and Beeper