Symbol LS 6000 Series Product Reference Manual page 21

5. Connect the other end of the interface cable to the
scanner.
Figure 2-2. Plugging Connector into Scanner
6. Set the LS 6000 to communicate with your particular
POS terminal by scanning the appropriate bar code(s).
Depending on your terminal, these are located either in
Chapter 5, Programming the LS
Interface Guide.
7. Power up the host terminal. Ensure that the scanner
driver port is enabled by following the terminal
instructions.
8. Verify that the scanner is successfully reading bar codes
and transmitting their content to the host terminal.
See What If... on page 4-5
completing these steps.
2-4
LS 6000 Series Product Reference Guide
if you are having problems after
6000, or the Synapse