Table of Contents
Advertisement
Chapter 5
Programming the LS 6000
Operational Parameters
The LS 6000 is shipped with the settings shown in the
Table 5-
1 beginning on page
5-2. These default values are stored in non-
volatile memory and are preserved even when the scanner is
powered down. You can change these default values by
scanning the appropriate bar codes included in this manual.
These new values replace the standard default values in
memory. The default parameter values can be recalled by
scanning the
SET ALL DEFAULTS bar code on page
5-7.
If you are using a Synapse cable, your host is autodetected, so
no host bar codes need to be scanned. If not, you must select a
terminal type even if the default parameters suit your needs. The
scanner automatically identifies the host type on power-up. It
makes this determination provided the host is powered-up
before the scanner is attached to it. You must then select the
appropriate terminal type for that host. For example, if the
scanner is connected to an IBM 4683, after you hear the power-
up beeps, select the proper port from the choices in
IBM 46XX
Host Types on page
5-8.
5-1
Advertisement
Table of Contents
