Programming the LS 6000
Time-out Between Decodes, Same
Symbol
This parameter sets the minimum time between decodes of the
same symbol. It is programmable in 0.1 second increments from
0.0 to 9.9 seconds. (Setting this above 0.4 seconds is
recommended.)
Scan the bar code below to select a new time-out. Next scan two
numeric bar codes beginning on page 5-117, the first
representing seconds, the second tenths of seconds. If you make
an error, or wish to change your selection, scan CANCEL on
page 5-122.
TIME-OUT BETWEEN SAME SYMBOL
5-23