Selecting Beeper Volume - Symbol LS 6000 Series Product Reference Manual

Selecting Beeper Volume

The LS 6000 emits a short beep when it successfully reads a bar
code. There are three volume settings for this decode beep. To
change the setting, hold down the trigger for five seconds. The
scanner cycles through three settings, emitting a 2-beep tone at
each setting. To select a particular setting, release the trigger
after the desired 2-beep tone.
Note: Beeper volume can also be set by
To adjust the frequency (tone) of the scanner's beeper, see
Frequency on page
3-4
LS 6000 Series Product Reference Guide
scanning the programming bar codes
for Beeper Volume on page
5-21.
5-19.
Beeper