Powering Up The Scanner - Symbol P470 Manual

P 4 7 0 /
Charging the Scanner in the Cradle
To charge the scanner, insert the
scanner into the cradle so the nose
of the scanner and tip of the handle
seat into the receptacles. The
scanner displays "UNIT CRADLED"
when properly inserted in the cradle.
The battery charges automatically. A
full charge of a depleted battery
takes approximately 3-1/2 hours.
The charge status indicator light on
the back of the cradle blinks then
becomes solid when the battery is
fully charged.

Powering Up the Scanner

To turn the scanner on, press the "Enter" key or pull the trigger.
The scanner is brought out of sleep mode and into scanning
mode.
Scanning
Consult the P470/P370 RF Scanners Product Reference Guide
(p/n 72-38495-xx) for programming instructions. If you need
assistance, contact your local supplier or the Symbol Support
Center.
1. Ensure the battery is
charged.
2. Make sure the bar code is
in the correct scanning
range. Aim and press the
trigger. When the scanner
has read the symbol:
- You hear a beep.
- The LED above the display turns green.
3 7 0 R F
2
S c a n n e r
Charge Status
Indicator Light