LS 6000 Series Product Reference Guide
Time to Return to Continuous
Omnidirectional
This parameter sets the time the scanner issues a single scan line
on trigger pull before returning to the constant-on
omnidirectional pattern. It is programmable in 0.1 second
increments from 0.0 to 9.9 seconds. If this value is set to 0, the
trigger mode will not return to constant-on omnidirectional
automatically. In this case, pull the trigger twice quickly to
return to the constant-on omnidirectional pattern.
To set this time, scan the bar code. Next scan two numeric bar
codes beginning on page 5-117, the first representing seconds,
the second tenths of seconds. If you make an error, or wish to
change your selection, scan CANCEL on page 5-122.
TIME TO RETURN TO CONTINUOUS OMNI
5-18