Regulated resistance
1.2–1.6 kΩ at 20°C (68°F)
Out of specification → Replace.
3. Check:
Front wheel sensor rotor "1"
G
Cracks/damage → Replace the front wheel
assembly.
NOTE:
The wheel sensor rotor of the vehicle is inserted
under pressure by a special process and cannot
be replaced as a single unit. To replace the sen-
sor rotor, replace the wheel assembly.
EAS21970
ADJUSTING THE FRONT WHEEL STATIC
BALANCE
NOTE:
After replacing the tire, wheel or both, the front
G
wheel static balance should be adjusted.
Adjust the front wheel static balance with the
G
brake disc installed.
1. Remove:
Balancing weight(s)
G
2. Find:
Front wheel's heavy spot
G
NOTE:
Place the front wheel on a suitable balancing
stand.
MMMMMMMMMMMMMMMMMMMMMM
a. Spin the front wheel.
b. When the front wheel stops, put an "X
at the bottom of the wheel.
c. Turn the front wheel 90° so that the "X
is positioned as shown.
d. Release the front wheel.
e. When the wheel stops, put an "X
the bottom of the wheel.
1
f. Repeat steps (d) through (f) several times un-
til all the marks come to rest at the same spot.
g. The spot where all the marks come to rest is
the front wheel's heavy spot "X".
LLLLLLLLLLLLLLLLLLLLLL
3. Adjust:
Front wheel static balance
G
MMMMMMMMMMMMMMMMMMMMMM
a. Install a balancing weight "1" onto the rim ex-
actly opposite the heavy spot "X".
NOTE:
Start with the lightest weight.
4-12
FRONT WHEEL
" mark
1
" mark
1
" mark at
2