Yamaha 2007 XP500 Service Manual page 97

1. Throttle cable
2. Fail-safe relay
3. ECU (ABS)
4. ABS test coupler
5. Cooling system air bleed hose
6. Storage box light switch lead
7. Coolant reservoir hose
8. Spark plug lead #2
9. Radiator fan motor lead
10. Sidestand switch lead
11. Spark plug lead #1
12. Rear brake lock lever cable
13. Stay 1
14. Rear brake hose
15. Hydraulic unit
16. Hydraulic unit solenoid coupler
17. Front wheel sensor coupler
A. Pass the rear brake lock lever cable on the front
side of throttle cable.
B. Position of clamp.
C. Position the relay straighten.
D. Route the main switch lead over the tube of the
stay 1.
E. Fasten the cooling system air bleed hose to the
stay 1 with a plastic holder.
F. After checking the ABS, install the ABS test
coupler into the stay 1.
G. The main switch lead couplers should not pro-
trude to the outside of the frame.
H. Fasten the fuel injection leads with a plastic
holder.
I. Fasten the sidestand switch lead to the frame
with a plastic holder.
J. Fasten the storage box light switch lead to the
frame with a plastic clamp. Face the clamp
clasp to the up side.
K. Route the rear brake lock lever cable to the left
of the bracket welded to the stay 1.
L. Fasten the rear brake hose to the stay 1 with a
plastic holder.
M. Route the throttle cable through the cable
holder.
2-60
CABLE ROUTING