Yamaha 2007 XP500 Service Manual page 25

To reset a tripmeter, select it by pushing the
"SELECT" button until "TRIP" or "TRIP F" begins
flashing ("TRIP" or "TRIP F" will only flash for
five seconds). While "TRIP" or "TRIP F" is flash-
ing, push the "RESET" button for at least one
second. If you do not reset the fuel reserve trip-
meter manually, it will reset itself automatically
and the display will return to the prior mode after
refueling and traveling 5 km (3 mi).
NOTE:
The display cannot be changed back to "TRIP F"
after pushing the "RESET" button.
Fuel meter
With the key in the "ON" position, the fuel meter
indicates the amount of fuel in the fuel tank. The
display segments of the fuel meter disappear to-
wards "E" (Empty) as the fuel level decreases.
When the fuel level reaches the bottom segment
near "E", the fuel level warning indicator and the
bottom segment will flash. Refuel as soon as
possible.
ECA15B1002
CAUTION:
If the fuel level is not displayed and the fuel
level warning symbol, triangular mark, "E"
line and "F" line flash in the fuel meter, the
fuel level monitoring system is malfunction-
ing. Check the fuel sender and the electrical
circuit.
Coolant temperature meter
With the key in the "ON" position, the coolant
temperature meter indicates the temperature of
the coolant. The coolant temperature varies with
changes in the weather and engine load. If the
top segment and coolant temperature warning
indicator flash, stop the vehicle and let the en-
gine cool.
ECA10020
CAUTION:
Do not operate the engine if it is overheated.
Oil change indicator "OIL"
This indicator flashes at the initial 1000 km (600
mi), then at 5000 km (3000 mi) and every 5000
km (3000 mi) thereafter to indicate that the en-
gine oil should be changed.
After changing the engine oil, reset the oil
change indicator. Refer to "CHANGING THE
ENGINE OIL" on page 3-13.
If the engine oil is changed before the oil change
indicator comes on (i.e. before the periodic oil
change interval has been reached), the indicator
must be reset after the oil change for the next
periodic oil change to be indicated at the correct
time. "CHANGING THE ENGINE OIL" on page
3-13
The electrical circuit of the indicator can be
checked according to the following procedure.
1. Set the engine stop switch to "
the key to "ON".
2. Check that the indicator comes on for a few
seconds and then goes off.
3. If the indicator does not come on, check the
electrical circuit. Refer to "SIGNALING SYS-
TEM" on page 8-23.
NOTE:
The oil change indicator may flash when the en-
gine is revved with the scooter on the center-
stand, but this does not indicate a malfunction.
V-belt replacement indicator "V-BELT"
This indicator flashes every 20000 km (12000
mi) when the V-belt needs to be replaced.
The electrical circuit of the indicator can be
checked according to the following procedure.
1. Turn the key to "ON" and make sure that the
engine stop switch is set to "
2. If the indicator does not come on, check the
electrical circuit. Refer to "SIGNALING SYS-
TEM" on page 8-23.
To reset the V-belt replacement indicator
1. Turn the key to "ON" and make sure that the
1-16
FEATURES
" and turn
".