Adjusting The Exhaust Gas Volume - Yamaha 2007 XP500 Service Manual

Out of specification → Adjust.
Make sure that the vacuum pressure is within
specification.
9. Stop the engine and remove the measuring
equipment.
10.Adjust:
Throttle cable free play
G
Refer to "ADJUSTING THE THROTTLE CA-
BLE FREE PLAY" on page 3-8.
Throttle cable free play
3.0–5.0 mm (0.12–0.20 in)
11.Remove:
Vacuum gauge
G
12.Install:
Side cover (left and right)
G
Center cover
G
Refer to "GENERAL CHASSIS" on page 4-1.
Seat
G
Refer to "GENERAL CHASSIS" on page 4-1.
EAS20600

ADJUSTING THE EXHAUST GAS VOLUME

NOTE:
Be sure to set the CO density level to standard,
and then adjust the exhaust gas volume.
1. Turn the main switch to "OFF" and set the en-
gine stop switch to "ON".
2. Simultaneously press and hold the "SE-
LECT" "1" and "RESET" "2" buttons, turn the
main switch to "ON", and continue to press
the buttons for 8 seconds or more.
NOTE:
All displays on the meter disappear except the
G
clock and tripmeter displays.
"dIAG" appears on the clock LCD.
G
1
2
3. Press the "SELECT" button to select the CO
adjustment mode "CO" or the diagnostic
mode "dIAG".
4. After selecting "CO", simultaneously press
the "SELECT" "1" and "RESET" "2" buttons
for 2 seconds or more to execute the selec-
tion.
1
2
5. Press the "SELECT" "1" and "RESET" "2"
buttons to select a cylinder.
NOTE:
The selected cylinder number appears on the
clock LCD.
To decrease the selected cylinder number,
G
press the "RESET" button.
To increase the selected cylinder number,
G
press the "SELECT" button.
1
2
6. After selecting the cylinder, simultaneously
press the "SELECT" and "RESET" buttons
for 2 seconds or more to execute the selec-
tion.
7. Change the CO adjustment volume by press-
ing the "SELECT" "1" and "RESET" "2" but-
tons.
NOTE:
The CO adjustment volume appears on the
tripmeter LCD.
To decrease the CO adjustment volume, press
G
the "RESET" button.
To increase the CO adjustment volume, press
G
the "SELECT" button.
3-7
ENGINE