Cleaning The Air Filter Element - Yamaha 2007 XP500 Service Manual

Adapter "2"
G
Pressure gauge
90890-03153
Oil pressure adapter B
90890-03124
2
6. Measure:
Engine oil pressure
G
(at the following conditions)
Oil pressure (hot)
150.0 kPa/1200 r/min (21.8 psi/
1200 r/min) (1.50 kgf/cm
min)
Oil temperature
70.0 °C (158.00 °F)
Out of specification → Adjust.
Engine oil
pressure
Below specification
Above specification
7. Install:
Main gallery bolt
G
O-ring
New
G
Main gallery bolt
12 Nm (1.2 m•kg, 8.7 ft•lb)
8. Install:
Left lower side cover mole
G
Refer to "GENERAL CHASSIS" on page 4-1.
1
2
/1200 r/
Possible causes
Faulty oil pump
G
Clogged oil filter
G
Leaking oil passage
G
Broken or damaged
G
oil seal
Leaking oil passage
G
Faulty oil filter
G
Oil viscosity too
G
high
EAS20920

CLEANING THE AIR FILTER ELEMENT

1. Remove:
Front cowling upper cover
G
Windshield
G
Front cowling inner panel
G
Refer to "GENERAL CHASSIS" on page 4-1.
2. Remove:
Air filter case cover "1"
G
Air filter element
G
1
3. Clean:
Air filter element
G
Apply compressed air to the outer surface of
the air filter element.
4. Check:
Air filter element
G
Damage → Replace.
5. Install:
Air filter element
G
Air filter case cover
G
(along with the gasket)
ECA1B706
CAUTION:
Never operate the engine without the air filter
element installed. Unfiltered air will cause
rapid wear of engine parts and may damage
the engine. Operating the engine without the
air filter element will also affect carburetor
synchronization, leading to poor engine per-
formance and possible overheating.
NOTE:
Make sure the air filter element is properly in-
G
3-15
ENGINE