Yamaha 2007 XP500 Service Manual page 81

1. Rear brake lock lever cable
2. Throttle cable (decelerator cable, double lock-
nut)
3. Fast idle inlet hose
4. Rear brake hose
5. A.C. magneto lead
6. Fuel tank breather hose
7. Coolant hose
8. Sidestand switch
9. Fast idle outlet hose
10. Radiator outlet hose
11. Crankcase breather hose
12. Throttle cable (accelerator cable, single lock-
nut)
A. Pass the rear brake lock lever cable to the cable
guide.
B. Route the wire harness through the frame
guide. At this time, place the protector (for the
handle cover inner side) on the bottom side.
C. Pass the fuel tank breather hose by the outside
of the wire harness.
D. Pass the wire harness by the outside of the rear
footrest mounting boss. (When installing the
rear footrest, do not catch or pinch the A.C.
magneto lead in the bracket.)
E. Fasten the wire harness to the frame with a
plastic holder.
F. Pass the storage box light switch lead by the
front of the frame back stay pipe.
G. Fasten the sidestand switch lead to the frame
with a plastic holder.
H. Pass the speed sensor lead to the lead holder
(2locations).
2-44
CABLE ROUTING