FrameMaker Ver.5.5E(PC) Di151 DIS/REASSEMBLY, ADJUSTMENT
00.03.21
4-2.
REMOUNTING EEPROM (U21)
NOTES
• If the Control Board has been replaced, be sure to remount EEPROM (U21) from the old
to new Control Board.
• If the Control Board has been replaced and EEPROM (U21) has not been remounted, be
sure to make settings and readjustments as necessary because New EEPROM (U21)
contains no data in this case.
1. Remove the Control Board.
2. Remove EEPROM (U21) from the new Control Board.
3. Remove EEPROM (U21) from the old Control Board and remount it onto the new Con-
trol Board.
New Control Board
A
A
4007D057AA
New EEPROM
Old Control Board
NOTE
Note the alignment notch (A) on EEPROM (U21) when
mounting the IC.
D-40
Old EEPROM
4007D056AA