FrameMaker Ver.5.5E(PC) Di151 TROUBLESHOOTING
00.03.10
(2)
Transport Misfeed
Paper Take-Up Sensor PS1
Paper Exit Sensor PS3
PJ8A-1(ANODE PS1)
PJ8A-2(GND)
PJ8A-3(PS1 ON)
PJ8A-4(ANODE PS3)
PJ8A-5(GND)
PJ8A-6(PS3 ON)
Transport Misfeed Clearing Procedure
• Paper has stopped near the PC Drum.
Step
Check
1
Transport Roller is dirty, deformed, or worn.
2
Pre-Image Transfer Guide Plate is dirty or
deformed.
3
Image Transfer Roller is dirty, deformed, or
worn.
4
PC Drum Paper Separator Fingers are dirty or
deformed.
• Paper has stopped at the Fusing Unit.
Step
Check
1
Fusing Guide Plate is dirty or deformed.
2
Fusing Roller is dirty, deformed, or worn.
3
Fusing Roller Paper Separator Fingers are
dirty, deformed, or worn.
4
Paper Exit Sensor operation: the voltage
across PJ8A-6 on the Master Board and GND
is DC0 V (sensor unblocked) and DC5 V (sen-
sor blocked).
Relevant Electrical Parts
Master Board PWB-A
CN3
1
3
2
2
1
3
PWB-A
T-5
PJ4
3
2
PS1
1
PJ5
3
2
PS3
1
4007C03TAB
Result
Action
YES Clean or change.
YES Clean or change.
YES Clean or change.
YES Clean. Or, change I/C.
Result
Action
YES Clean or change.
YES Clean or change.
YES Clean, correct, or change.
YES Change Master Board.
NO
Correct actuator.
Change sensor.