Fd Registration Adjustment (Paper Tray - Minolta Di151 Service Manual

FrameMaker Ver.5.5E(PC) Di151 DIS/REASSEMBLY, ADJUSTMENT
00.03.21
(5)

FD Registration Adjustment (Paper Tray)

Requirement
c
4007D051AA
Requirement
A4C 20 ±2.0 mm
NOTE
This adjustment must be made whenever the PH Unit is replaced. Should be made after
the CD registration adjustment (Paper Tray) has been completed.
Procedure
1. Produce a test pattern (F5: Test Pattern 1).
2. Make sure that dimension C on the test pattern falls within the specified range. If it falls
outside the specified range, perform the following adjustment procedure.
3. Enter Adjust function AA.
4. Change the setting value using the 1Key or 10Key as necessary (1 step equivalent to
0.5 mm).
If dimension C on the test pattern is longer than the specified range, decrease the setting
value.
If dimension C on the test pattern is shorter than the specified range, increase the setting
value.
If one adjustment sequence does not bring the dimension into the required range, per-
form the sequence again.
5. Press the Start key to validate the setting value.
NOTE
If the Clear/Stop key is pressed to go back to the Basic screen without pressing the Start
key, the setting will be restored to the original value.
Dimension C on the test pattern produced should fall
within the range specified below.
Adjust Mode Function
FD registration
adjustment
D-34
Setting Range
43 to 57
(-3.5 to +3.5 mm)