Controller Options - HP ProLiant DL180 Gen9 User Manual

Install the primary PCI riser cage
b.
Route the split ends of the Mini-SAS Y-cable through the cable clip on the air baffle, and then
c.
connect the cable to the drive backplane.
Secure the Mini-SAS Y-cable in the right front chassis cable clip.
d.
Install the access panel (on page 25).
9.
Do one of the following:
10.
Slide the server into the rack.
o
Install the server into the rack
o
Power up the server (on page 20).
11.
If you are planning to install new drives, install them now
12.

Controller options

The server ships with an embedded HP Dynamic Smart Array B140i Controller. For more information about
the controller and its features, see the HP Dynamic Smart Array B140i RAID Controller User Guide on the HP
website (http://www.hp.com/go/smartstorage/docs).
Upgrade options exist for an integrated array controller. For a list of supported options, see the product
QuickSpecs on the HP website (http://www.hp.com/go/qs).
To configure arrays, see the HP Smart Storage Administrator User Guide on the HP website
(http://www.hp.com/go/smartstorage/docs).
The server supports FBWC. FBWC consists of a cache module and an HP Smart Storage Battery Pack. The
DDR cache module buffers and stores data being written by an integrated Gen9 P-series Smart Array
Controller.
This server supports the 96-W HP Smart Storage Battery Pack. This battery pack can support up to 24
devices. Devices in this context refer to the HP Smart Array Controller or NVDIMM associated with the cache
module.
The battery pack might have a low charge when installed. If the battery does have low charge, a POST error
message appears when the server is powered up, indicating that the battery pack is temporarily disabled.
("Install the PCI riser
("Installing the server into the
cages" on page 26).
rack" on page 36).
("Drive options" on page 42).
Hardware options installation 64