Enabling The Dedicated Ilo Management Module - HP ProLiant DL180 Gen9 User Manual

Install the dedicated iLO management module.
8.
If removed, install the expansion board.
9.
Install the access panel (on page 25).
10.
Do one of the following:
11.
Slide the server into the rack.
o
Install the server into the rack
o
Power up the server (on page 20).
12.
Enable the dedicated iLO connector
13.

Enabling the dedicated iLO management module

The onboard NIC 1/shared iLO connector is set as the default system iLO connector. To enable the installed,
dedicated iLO management module in a server operating in:
•
Legacy BIOS Boot Mode, use the iLO RBSU.
For more information on this utility, see the HP iLO 4 User Guide in the HP website
(http://www.hp.com/go/ilo/docs).
•
UEFI Boot Mode, use the iLO 4 Configuration Utility.
For more information on this utility, see the HP UEFI System Utilities User Guide for HP ProLiant Gen9
Servers on the HP website (http://www.hp.com/go/uefi/docs).
IMPORTANT:
machine will be lost. Access the physical machine and repeat the procedure described in this
section to re-enable the dedicated iLO management connector.
To enable the dedicated iLO management module in Legacy BIOS Boot Mode:
During the server startup sequence after module installation, press F8 in the POST screen.
1.
The iLO RBSU screen appears.
Select Network | NIC and TCP/IP.
2.
The Network Configuration screen appears.
("Installing the server into the
("Dedicated iLO management module
If the iLO configuration settings are reset to the default values, remote access to the
rack" on page 36).
option" on page 90).
Hardware options installation 91