HP ProLiant DL180 Gen9 User Manual page 37

WARNING:
equipment:
Observe local occupational health and safety requirements and guidelines for manual
•
material handling.
• Get help to lift and stabilize the product during installation or removal, especially when the
product is not fastened to the rails. HP recommends that a minimum of two people are required
for all rack server installations. A third person may be required to help align the server if the
server is installed higher than chest level.
• Use caution when installing the server in or removing the server from the rack; it is unstable
when not fastened to the rails.
CAUTION: Always plan the rack installation so that the heaviest item is on the bottom of the rack.
Install the heaviest item first, and continue to populate the rack from the bottom to the top.
To install the server in an HP, Compaq-branded, Telco, or a third-party rack:
Install the server and cable management arm option into the rack. See the documentation that ships with
1.
the Easy Install Rail Kit.
Connect peripheral devices to the server. For information on identifying connectors, see "Rear panel
2.
components (on page 11)."
WARNING:
telephone or telecommunications connectors into RJ-45 connectors.
To prevent the accidental disconnection of the power cord when sliding the enclosure into and from the
3.
rack, secure the power cord through the strain relief clip:
If the clip is positioned too near the power cord that it blocks the power cord plug connection, slide
a.
the clip backward.
Connect the power cord to the server.
b.
Press the top part of the clip, and then pull the clip open.
c.
This server is very heavy. To reduce the risk of personal injury or damage to the
To reduce the risk of electric shock, fire, or damage to the equipment, do not plug
Setup 37