HP ProLiant DL180 Gen9 User Manual page 72

Install the optical drive into the bay.
7.
If an expansion board is installed in the primary PCI riser cage, then remove the PCI riser cage
8.
("Remove the PCI riser
Connect the optical drive cable:
9.
Connect the optical drive cable to the optical drive.
a.
Connect the four-pin (2x2) power supply cable to the power connector of the optical drive cable.
b.
Secure the optical drive cable in the two front chassis cable clips.
c.
Connect the cable to the SATA connector on the system board.
d.
If removed, install the primary PCI riser cage
10.
Install the access panel (on page 25).
11.
Do one of the following:
12.
Slide the server into the rack.
o
Install the server into the rack
o
cages" on page 25).
("Install the PCI riser
("Installing the server into the
cages" on page 26).
rack" on page 36).
Hardware options installation 72