Connecting The Mini-Sas Y-Cable Option For 8-Bay Sff Hot-Plug Drive Configurations - HP ProLiant DL180 Gen9 User Manual

Install the primary PCI riser cage
b.
Route the split ends of the Mini-SAS Y-cable through the cable clip on the air baffle, and then
c.
connect the cable to the drive backplane.
Secure the Mini-SAS Y-cable in the right front chassis cable clip.
d.
Install the access panel (on page 25).
9.
Do one of the following:
10.
Slide the server into the rack.
o
Install the server into the rack
o
Power up the server (on page 20).
11.
If you are planning to install new drives, install them now
12.
Connecting the Mini-SAS Y-cable option for 8-bay SFF hot-plug
drive configurations
This section explains how to connect the 630-mm Mini-SAS Y-cable option to upgrade the fixed 8-bay SFF
hot-plug drive cage (box 3) connection from the onboard storage controller or from an HBA to an HP Smart
Array P-series Controller.
To connect the cable option:
Power down the server (on page 20).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 20).
o
Remove the server from the rack (on page 22).
o
Remove the access panel (on page 24).
4.
("Install the PCI riser
("Installing the server into the
cages" on page 26).
rack" on page 36).
("Drive options" on page 42).
Hardware options installation 61