Configuring Global Parameters Of A Stack - HP 1920 Gigabit Ethernet Switch Series User Manual

Task
Configuring member devices of a stack:
Configuring stack ports
Displaying topology summary of a stack
Displaying device summary of a stack
Logging in to a member device from the
master

Configuring global parameters of a stack

Select Stack from the navigation tree to enter the page shown in
parameters of a stack in the Global Settings area.
Remarks
Required.
Configure a port of a member device that connects to the master
device or another member device as a stack port.
By default, a port is not a stack port.
Optional.
Display information about stack members.
Optional.
Display the control panels of stack members.
IMPORTANT:
Before viewing the control panel of a member device, you must make
sure the username, password, and access right you used to log on to
the master device are the same with those configured on the member
device; otherwise, the control panel of the member device cannot be
displayed.
Optional.
Log in to the Web network management interface of a member
device from the master device.
IMPORTANT:
Before logging in to a member device, you must make sure the
username, password, and access right you used to log on to the
master device are the same with those configured on the member
device. Otherwise, you cannot log in to the member device. You can
configure them by selecting Device and then clicking Users from the
navigation tree.
40
Figure 26. You can configure global